![]() ++ Regular GRE tunnel has destination address, but mGRE do not have any specific destination. ++ nhrp network-id need to be same for all the sites. ++ nhrp authentication helps to prevent unauthorized peer to join. So, next configuration part will be DMVPN configuration. Success rate is 100 percent (5/5), round-trip min/avg/max = 3/3/5 msĬommunication is successful. Sending 5, 100-byte ICMP Echos to 202.7.0.2, timeout is 2 seconds: Success rate is 100 percent (5/5), round-trip min/avg/max = 3/3/6 ms Sending 5, 100-byte ICMP Echos to 59.152.100.2, timeout is 2 seconds: Now, lets verify the reachability from HO to BRA-01 & BRA-02. ++ JUNIPER – How to configure Multi-Area OSPF on Juniper HO: ++ JUNIPER – How to configure OSPF on Juniper ++ CISCO – How to Configure OSPF Authentication ++ CISCO – How to configure OSPF in Cisco Router If you want to learn more about OSPF, you check out below contents. ![]() ![]() ![]() Here, i am using OSPF to connect to the ISP. Now we need to configure routing between routers. After that, we will configure OSPF between routers, so that WAN IPs can reach each other. First of all, let’s configure IP addresses on all the routers including ISP. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |